1974 Bertram

About This Vessel

measures 35 ft, and is located in Melbourne, Florida.

Release Marine 80 class fighting chair goes with the boat. Two a/c units. Cruisair turbo self-contained 16,000 btu salon a/c with reverse cycle heat new in 2024 installed under flybridge dash. Old plywood duct box replaced with pvc panel board. Forward stateroom Cruisair self-contained 8,000 btu with reverse cycle heat installed in back of stateroom locker.Repowered from gas to diesel by Delta Custom boat works in Cape Canaveral. Old gas engines were 454 ci, 350 hp. This was a major refit changing shafts to 1 3/4", props (spares included), increasing raw water intake and strainer size,increasing exhaust ports, and mufflers. Saddle tanks were also added for a total of 440 gal.Engines are 2337 hrs, genset has 3174 hrs.No longer have lower station gauge panel. But do have Cummins mechanical guage panel from flybridge when changedto digital engine displays. This boat has full NMEA 2000 connectivity including engine displays, all navigation electronicsand even Fusion stereo.Gel coat has thinned in some areas. Would recommend painting.No known structural or mechanical issues. Cross beam under cockpit bulkhead was replaced during engine refit with fiberglass beam. Same for cockpit bulkhead.Boat has primarily made Bahama trips.Owner usually cruise the boat between 22 and 24 knots, sometimes 25 knots. All depending on how heavily loaded. This corresponds to roughly 2200 rpm, 2400 rpm, and 2500 rpm. Engines top out at 3000 rpm, 29.5 knots.Two saddle tanks plus main tank. Range at cruise is roughly 400 nm.Fresh water tank is 50 gal. Holding tank is approximately 13 gal.17 degree deadrise midship, (measured for tilt element transducer.)31' to top of triggers30' to top of antennas21' to outrigger tips extended18' to masthead light.Engines and Generator are 2000. It is offered as a convenience by this broker/dealer to its clients and is